D'MAND® System Accessories
The ACT D’MAND pump can be activated by a hardwire push button, hardwire motion sensor, wireless remote, or wireless motion sensor. If you are looking for hot water plumbing pump parts, then you can view the accessories on the product page. Every ACT D’MAND pump comes with 1 hardwire push button which wires back to the pump via low voltage wire (CAT 5 or doorbell wire). The user can order as many additional push buttons as he wishes; all buttons have to be wired back to the pump using low voltage wire.
For users who are retrofitting the pump into their homes and cannot run wire to the pump, ACT has wireless remote activators and wireless motion sensor activators. The user can use as many wireless remote activators as he wishes and up to 10 wireless motion sensors per wireless receiver. ACT’s activation methods allow it to be the best performing on-demand pump on the market. Other manufacturers do not provide the same plumbing pump parts that ACT does.
The user can use the hardwire push button in tandem with the wireless remote activator or the wireless motion sensor, but cannot use the wireless motion sensor with the wireless remote activator. The reason for this is that the wireless remote activator uses a 5 Volt activation switch within the pump and the wireless motion sensor uses a 12 Volt activation switch within the pump.
-
Hard Wire Buttons (B-922G $5.20)
Gold button wired back to the pump via CAT5 or 22-gauge Bell Wire.
-
Hard Wire Buttons (B-906S $5.20)
Silver button wired back to the pump via CAT5 or 22-gauge Bell Wire.
-
Wireless Transmitter Kit (RT-954 $55.00)
Includes 1 Hard-Wired Receiver (R-954) and 1 Wireless Transmitter (T-954). Receiver (R-954) must be wired to the D'MAND System. CANNOT be used in conjunction with Motion Sensors (VS-1107, V-1209, VS-0411).
-
Wireless Transmitter (T-954 $21.99)
Additional (12-Volt) battery operated Transmitter to be used with RT-954 Kit. An unlimited number of Transmitters (T-954) may be used with Hard-Wired Receiver (R-954). Receiver must be wired to the D'MAND System.
-
Hard -Wire Motion Sensors (V-1209 $75.00)
Up to twelve (12) Hard-Wired Motion Sensors may be used with one (1) D'MAND System, must be Hard-Wired back to the pump via CAT5 or 22-Gauge Bell Wire.
-
Wireless Motion Sensor Kit (VRS-1107 $198.00)
(12-Volt) Dual beam/curtain style Wireless Motion SensorKit Includes 1 Wired Receiver (VR-1107) and 1 Wireless Motion Sensor (VS-1107). May be wall or backsplash mounted. (VS-1107) Wireless Motion Sensor CANNOT be used in conjunction with Wireless Transmitters (T-954).
-
Wireless Motion Sensor (VS-1107 $126.00)
Additional (12-Volt) battery operated dual beam/curtain style Wireless Motion Sensor to be used with VRS-1107 Kit. Up to ten (10) Wireless Motion Sensors may be used with one (1) Hard-Wired Motion Receiver (VR-1107).
